How to Flush a Chattanooga Water Heater

Posted by on Jan 17, 2014 in Water Heater Repair Chattanooga

Ok, so it is not a glamorous water heater upkeep job, however it does require a little cleaning up from time to time. Yes, today Water Heater Repair Chattanooga is going to instruct one on the best ways to eliminate a water heater. Some suggest doing this once every one to three years, we feel it is best to do so when a year. Doing so is not a tough or time consuming job – heck, let the children assist even.

Why Flush a Chattanooga Water Heater?

If it is last the suggested life expectancy of the device, it should have some kind of regular flushing done. Doing this will undoubtedly assistant in having it run as effectively as possible, which also indicates saving money on the expenditure of running the darn thing. That alone should be a good enough reason we feel!

In regards to water heater maintenance, flushing it will do away with the accumulation of mineral deposits that natural happens inside the water storage tank. If one has ever had loud sounds, popping, gurgling, mini-explosion noises, that is an indicator that there is too much sediment inside the tank. This flushing procedure will assist make certain that the tank warms water far more quietly.

Step 1. If it is an electric water heater, turn the power off in the main electric breaker box and turn the cold water supply off. If it is a gas heater, it is ok to leave the gas on – just turn the water off. Though, turn the thermostat setting dial to the pilot setting (make a note to remember exactly what it was initially set at though for later on). Then, whichever faucet the water heater supplies is closest requires to be opened. This is usually much easier than opening the pressure relief valve, but one can do that rather.Water Heater Repair Chattanooga

Step 2. At the bottom of the water heater is a drain valve that a yard watering hose can be connected to. There might be a cover over it depending on the maker. Consider turning the heat to the pilot setting numerous hours before flushing it if one desires so the water isn’t going to be as hot when it is drained. If that is not an alternative that’s great, simply ensure the yard hose utilized is in good condition to withstand the higher temperature water.

Run the hose outside far from the house or if the water has cooled, one can drain the tank into containers.

Step 3. Open the water heater’s drain valve and start draining the water. For whatever reason the drain valve is usually made of plastic, so if one has an older water heater (and one that has actually not been drained since before time started) it may stick a little. Just be careful to not break the plastic (which is why it would be good if the darn thing was NOT made of plastic).Water Heater Repair Chattanooga TN

When the drain valve is open, likewise open the pressure relief valve on the unit. Water will (a minimum of it must if it pressure relief valve is working properly) flow some from it. Try to let is stream stable and not too quick so it stirs up the sediment in the water heater. We want the sediment to drain out the bottom from the hose.

If draining in a bucket, even if having the hose drain into a container beyond the garage or basement where the water heater is found, fill a container and let it sit to see if the water is clear or if there is sediment, which will usually look like sand in the bottom of the container. Simply keep draining it till the water is clear.

Step 4. Close the drain on the bottom of the tank and close the pressure relief valve if it is still open.

Step 5. Turn the water supply on again to fill the tank. Once it is full once more, slowing open the pressure relief valve once again to get some excess air out of the tank. Then, open a hot water faucet in the home to get much more air out of the system.

Step 6. Let the hot water in the bathtub run up until a complete stream is streaming out. When that takes place, it is ok to turn the power back on if it is an electric water heater, or reset the temperature level setting for a gas water heater. Certainly, turn the bathtub faucet off. In about 20 minutes, the hot water ought to be heated up once more.

There you go! Water Heater Repair Chattanooga TN is here to answer any concerns you might have. Next take a look at our post on what to do if one has no hot water.

Enhanced by Zemanta